ERICSSON TELEPHONE No. N1010A and N1010B

How to convert the N1010 to work on the UK plug and socket system

N1010B to diagram N18835 (this is a cheapened set and transmission quality may be poor)

  1. Remove one of the wires from the capacitor (grey square component).
  2. Remove the link between baseplate terminals A and EB.
  3. Insert a 3.3k resistor between baseplate terminals A and EB.
  4. Connect red of the new line cord to baseplate terminal B.
  5. Connect white of the new line cord to baseplate terminal A.
  6. Connect Blue of the new line cord to the baseplate unmarked terminal.
  7. Insulate the green of the new line cord.
  8. If possible connect a rectifier element across the terminals of the receiver in the handset.

N1010A or N1010B to diagram N19995

  1. Remove one of the wires from the capacitor (grey square component).
  2. Remove the link between baseplate terminals L1 and EB.
  3. Insert a 3.3k resistor between baseplate terminals L1 and EB.
  4. Connect red of the new line cord to baseplate terminal L2.
  5. Connect white of the new line cord to baseplate terminal L1.
  6. Connect Blue of the new line cord to baseplate terminal C.
  7. Insulate the green of the new line cord.
  8. Connect a rectifier element between terminals 2 and 3 inside the body of the phone.

 

BACK Home page BT/GPO Telephones Ericsson Telephones Ericsson Home Page Ericsson PABX All Telephone Systems
Last revised: June 12, 2010