USER PROGRAMMING GUIDE
6 Exchange lines and 16 Extensions. (100 Watts)2 Intercom circuits.
Approved for LD & MF to the Exchange.
ccu Colour LJU 2/3C A White/Blue 3 - Speech B Blue/White 4 - Speech C White/Orange 5 - Data D Orange/White 2 - Data Spare White/Green 1 Spare Green/White 6
Line Dedicated LJU 1 LJU 2/1A 2 LJU 2/1A
Only possible from EXTENSION 11
High level programming Password required.
Low level Programming # only required.
Default password 2745.
Press #-Exchange line 1 2745 * Hold Hold.
On completion Exchange lines 1-5 light for 10 seconds.
System now configured for LD 65135 break/make ratio, all terminals to ring, all exchange lines accessible from all terminals, no call barring, all terminals to ring during night service, TB recall, recall time set to 1.28 seconds, pause time set to 1.67 seconds, reverted ring set to 30 seconds.
For MF Signalling
Press #exchange line 1
Enter password 2745
Key 9 # #
Replace handset or SPK key.
This will return the system to its default initialisation values but it will be set to MF signalling and will retain all ABB dialling numbers and will not affect any calls in progress.
#91 = ON
#90 = OFF
1. Press #MEM 2 digit code 0 1 to 1 0.
2. Press line to be used.
3. Dial number to be stored.
4. Replace handset.
TO INVOKE DND
Press DND (if provided) or Press SPK or MON twice within 1 second (MEM LED flashes slowly).
TO CANCEL DND
Press DND (if provided) or Press SPK or MON twice within 1 second (MEM LED goes out)
To choose the extension to receive your calls.
# HOLD ! LINE 2 ! Dial Extn No. ! Clear down
Press HOLD - MEM light flashes rapidly
TO CANCEL DIVERT
Press HOLD - MEM light goes out
# ! HOLD ! HOLD1 ! LOCK CODE ! Clear down
Same as above
Page group 1 - dial 01
Page group 2 - dial 02
Page group 3 - dial 03
Page group 4 - dial 04
All groups - dial 00
1. Dial required group
2. Make announcement
3. Clear down
Last revised: January 12, 2001