Siemens Brothers P.A.B.X. Systems

The No. 16 System employs the well-known types of Siemens 10 point uniselector, two-motion selector and similar circuits to those used in their No. 16 non-director exchanges.

These items are mounted on open type racks, and so many of each assembled in this manner form a P.A.B.X. automatic unit.

Systems working on the No. 16 principle are classified as "small" and "large" P.A.B.X. systems.

Small P.A.B.X's are worked on a two-digit basis, and large P.A.B.X's on a 3-digit basis. Both employ 10 point uniselectors and in three-digit systems 1st and 2nd preselectors are installed. The first preselector is a homing type, and the second a non-homing type. Both are stepped, by means of impulses delivered from an impulse machine, at 34 steps per second and the rotary motion of two-digit selectors is also affected in this manner. Three-digit systems employ intermediate (or group) selectors to deal with the 100's digit.

100 outlet final selectors are installed in both large and small P.A.B.X's.

Calls to the manual board are obtained by dialling "0," which causes the final selector in two-digit systems and the group selector in three-digit systems to take ten vertical steps.

Normal post springs are provided which are actuated on the tenth level, and bring about the operation of the manual board calling lamp associated with the calling extension. All the automatic equipment taken into use is then released. The caller hears ringing tone until the operator answers.

Direct access and tie line facilities may be provided on levels 9 or 8 respectively, by the addition of suitable relay sets wired to the bank contacts of these levels. Since the transmission bridge in the Siemens No. 16 system is located in the first selector in three-digit systems it is necessary to convert these selectors into repeaters or to cut them out of circuit when digits 8 or 9 are dialled.

P.G. and magnet alarm circuits are provided, but no provision is made for the forced release of automatic equipment taken into use under P.G. conditions.

Messrs. Siemens well known type of relay is employed throughout.

The systems operate on 60 volts, the range for satisfactory operation being from 54-66 volts.

Taken from a paper by the IPOEE dated 1932 (No. 142)

Typical installation



BACK Home page BT/GPO Telephones Search the Site Glossary of Telecom Terminology Quick Find All Telephone Systems

Last revised: June 18, 2022