| No. 1 2.6" long, with insulated handle; end offset and slotted. Used for adjusting interrupters of
A.T. & E. Co., S.T. & C. and Ericssons' uniselectors. |
 |
| No. 2
5.5" long, made from 1/4" round-section steel, double-ended, each end offset and slotted. Used for adjusting interrupter levers of
P.O., G.E.C. and Siemens' No. 50 uniselectors. |
 |
| No. 3
7 in. long, round-section steel, with wood handle. End offset and slotted. For adjusting interrupters of
S.T. & C. Bypath uniselectors. |
 |
| No. 4
4.25" long, made of 1/4" square-section steel, one end offset and slotted. Used for adjusting the
interrupter rear arm of 2000-type selectors. |
 |
| No. 5
4.2" long, made of 3/8" x 1/4" steel, double-ended, each end slotted. A hole is provided through the width for a tommy bar. Used for adjusting the vertical interrupter strikers of 2000-type selectors, also as a holder for the rotary interrupter lever of
2000-type selectors. |
 |
| No. 6
5.25" long, made from 1/4" round-section steel, double-ended, each end offset and slotted. Used for adjusting the rotary interrupter
strikers of 2000-type selectors. |
 |
| No. 7 |
|
| No. 8
Used for the adjustment of Uniselectors No. 3 |
 |