USER PROGRAMMING GUIDE MARQUIS 1 6 Exchange lines and 12 Extensions. (60 Watts) 2 Intercom circuits. Approved for LD & MF to the Exchange. LJU Wiring ccu   Colour LJU 2/3C A White/Blue 3 - Speech B Blue/White 4 - Speech C White/Orange 5 - Data D Orange/White 2 - Data Spare White/Green 1 Spare Green/White 6 POWER FAIL Line Dedicated LJU 1 LJU 2/1A 2 LJU 2/1A INITIALISE SYSTEM All system programming is performed from extension 70. Lift handset and Key INT #08 Default:- All terminals ring to incoming calls. All exchange lines on all terminals. No call barring. Loop/dis signalling. Lift handset and Key INT #09 Defaults:- Same as above but MF signalling. If Marquis 2 terminal used press MEM instead of INT. SYSTEM PARAMETERS (Programmed at extension 70 with handset off) A1 EARTH OR TIMED BREAK RECALL Key INT #00 then 0 = Timed break or 1 = Earth. A2 PAUSE TIME (PIGGY-BACK ON PABX) Key INT #02 then 00001101 Gives a pause time of ONE second. 00010101 would give 1.8 seconds. 00110010 would give 5 seconds. A3 MAKE /BREAK RATIO Key INT #02 then 1 1001000 Gives 66133s A4 TIMED BREAK RECALL TIMER Key INT #03 then 00000001 If having difficulties increase time to 1.25 seconds by using the code 00001111. A5 REVERTED RING Key INT #04 then 00000110 Gives reverted ring time of 30 seconds. Use 00001 100 to increase delay to 1 minute. A6 VOICE ANNOUNCE (IF AVAILABLE) Only fully functional with executive to executive calls. Key INT #05 then: 0 = to enable or 1 = No voice announcement. TO PROGRAMME TERMINALS At terminal 70. Lift handset. Key INT # Extension number then SIXTEEN digits. CALL BARRING, COLUMNS 1 & 2. If required enter 01. If not required enter 00. EXCHANGE LINE ACCESS, COLUMNS 3-8 For each line to appear enter 1. For lines not appear enter 0. COLUMN 9 CALL INTRUDE Warning tone on an I/C call. Waiting to he answered. COLUMN 1 0 NIGHT SERVICE DEFAULT IS ON 0 = NOT subject to night service. 1 = Subject to night service. EXCHANGE LINES TO RING AT TERMS, COLUMNS 11 - 1 6 For lines to ring enter 1 For lines not to ring enter 0 TO ENABLE NIGHT SERVICE FROM TERMINAL 70 1. Lift handset or key INT. (listen for Dial tone). 2. Press # (INT key extinguished). 3. Key 831. 4. Replace handset. TO DISABLE NIGHT SERVICE FROM TERM 70 1 . Lift handset or press INT. (listen for Dial tone) 2. Press # (INT extinguished D/Tone removed). 3. Key 830. 4. Replace handset.
	BACK Home page BT/GPO Telephones Search the Site Vehicles Home Page Quick Find All Telephone Systems Last revised: February 27, 2021 FM2